Weidmuller WI-MOD-E-G Instrukcja Użytkownika Pobierz pdf (Strona 25)

Page 25 February 2010

3.4.2 Set WI-MOD-E to same network as PC

This is the alternate procedure to setting an IP address in the WI-MOD-E. Consult your network

administrator for an IP address on your network, the gateway IP address, and network mask.

a) Switch Factory Default dip-switch on WI-MOD-E to SETUP position.

b) Connect the RS232 port on the WI-MOD-E to the RS232 port on the PC using a “straight-

through” serial cable.

c) Open a terminal package (such as HyperTerminal) with 19200bps data rate, 8 data bit, 1 stop,

no parity and no flow control. Make sure that no other programs have control of the serial port.

d) Power up WI-MOD-E. Basic network settings will be displayed on the terminal as illustrated

below. When prompted, hit enter key to stop automatic boot process. You have 5 seconds to

abort the boot process.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 89 90

Brak uwag

Weidmuller WI-MOD-E-G Instrukcja Użytkownika Strona 25