Weidmuller WI-I/O 9-L: Wireless I/O Transmitter / Receiver v1 Instrukcja Użytkownika Pobierz pdf (Strona 31)

WI-I/O 9-L Configuration Manual

WI-I/O 9-L Wireless I/O page 31 of 108



WI Series uses a system address to group modules in a system. Modules ignore messages

from modules not sharing share their system address to prevent “cross-talk” between

modules in different systems.

Separate networks with different system addresses can operate independently in the same

area without affecting each other.

The system address can be any number between 1 and 32 767. The actual value of the

system address is not important; however you must use the same system address for all

modules in the same system or they cannot communicate with each other.

Note

You should NOT use a system address of zero.

If you change the system address for an existing project, you must re-program all

modules in the system.

When setting the system address, the WI-I/O 9-L randomly selects a system address;

however you can change the system address if required.

To set the system address:

1. Open the project.

2. Enter the system address:

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 107 108

Brak uwag

Weidmuller WI-I/O 9-L: Wireless I/O Transmitter / Receiver v1 Instrukcja Użytkownika Strona 31